Pyramid DC Receiver Manuel d'installation télécharger pdf (Page 9)

Page 9

Installation Manual Pyramid Universal Dome Interface

CONNECTING AN ULTRAK DOME CAMERA

3. On the dome camera itself there is a PCB which includes three rotary switches. These rotary switches are labelled

S1, S2 and S3, and they should be used to set the dome address to 1. To do this, set the first rotary switch (S3) to

0, the second rotary switch (S2) to 0 and the third rotary switch (S1) to 1, as shown below:

S4 S3 S2 S1

White indicate

switch positio

Configuring an Ultrak Dome

4. Next to the three rotary switches, there are four dip switches (S4) which are used to set the dome protocol. The

dome protocol should be set to Maxpro. To do this for Ultrak firmware versions J and later, push the first switch

DOWN and leave the remaining three switches UP, as shown in the diagram above.

5. Refit the dome camera into the housing.

CONNECTING A VCL DOME CAMERA

To connect a VCL dome camera to the UDI, follow the steps below:

CAUTION

When connecting the UDI to a dome, reference should also be made to documentation provided with the dome.

1. Unscrew the lid of the weatherproof box which contains the power supply unit for the dome camera.

2. Connect the six-way terminal block labelled CON3 to the wire from the UDIs Dome Data Connector. Use the

diagram below as a guide:

GND

VIDEO

24V AC

DATA -

DATA +

WIRES FROM DOME DATA CONNECTOR ON UDI:

FROM - TERMINAL

FROM GROUND TERMINAL

FROM + TERMINAL

CON3

Connecting a VCL Dome to the UDI

3. Fix the lid back in place.

4. Remove the weatherproof screen from the dome camera itself to reveal the camera PCB.

5. Using the block of eight dip switches labelled ADDRESS, set the dome address to 1. To do this, move the switch

labelled 1 to the ON position and ensure the other seven switches are set to the OFF position, as shown below:

ADDRESS

White indicates

switch positio

Configuring a VCL Dome

6. Refit the weatherproof screen to the dome camera.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Pas de commentaire

Pyramid DC Receiver Manuel d'installation Page 9